← Living
Living

Samsung Jet brush cleaning: remove and refit the LED floor brush roller

Unsure whether to wash your Samsung Jet floor brush? Identify the attachment first. This guide covers the LED 마루 브러시 플러스 roller, its alignment marks and the next checks when cleaning does not stop noise or restore rotation.

Storage baskets on a wooden shelf; reference photograph

Based on the sources linked below. The photograph is for illustration.

Before you start

STEP BY STEP

Here’s how

01

1. Identify the floor attachment, not just the vacuum

These steps apply to the BESPOKE Jet AI attachment called LED 마루 브러시 플러스 in Samsung Korea's guide. Do not transfer them to a wet-mopping attachment or a different roller simply because the vacuum carries the Jet name. Locate the rear PUSH button and the open/locked alignment marks. For example, if you emptied the dustbin but still hear noise at floor level, inspect the brush for debris next. This is a suggested troubleshooting sequence, not a diagnosis of the noise.

02

2. Switch off before removing the roller

Stop the vacuum and switch off the main unit. Release the brush from the extension pipe, then press the rear PUSH button to remove the roller. Pull off its retaining piece by hand. Note the orientation, or take a photo before removal, so you can compare it during reassembly. If the buttons or components differ, consult the manual for your model instead of forcing them.

03

3. Remove trapped debris, then wipe the residue

Remove debris caught on the roller and wipe away what remains with a dry cloth or wet wipe. Do not rinse or immerse this brush. Permission to use a wet wipe does not mean the attachment is washable under running water. Do not use it to pick up water from the floor either. Keep the detached retaining piece somewhere it cannot get lost.

04

4. Align open to insert, then locked to secure

Refit the retaining piece to the roller. Insert the roller with the open mark aligned to the line on the transparent window. Pull the back of the retaining piece upward until it clicks into place, and check that the locked mark now aligns with the window line. A roller merely fitting into its opening is not enough. If the marks do not line up, review the orientation before switching on.

05

5. Use the result to decide what comes next

Once reassembled, check rotation and noise. Samsung's brush-noise guidance says that if the roller still will not turn after cleaning, overheating protection may have activated; allow at least 30 minutes to cool before trying again. Persistent noise may require inspection of the brush motor. Removing debris does not prove that every fault is resolved. If the problem remains, record the model and what changed after cleaning for a service consultation.

Sources & further reading

Samsung Korea Service — LED 마루 브러시 플러스 roller care ↗Samsung Korea Service — brush noise and a stopped roller ↗

Some sources are in Korean. Check the original guidance for current product, store or software conditions.

Read this article in Korean →