← Living
Living

Philips HR2004/70 blender cleaning: pulse with no more than 500ml of water

Do you fill the jar and leave it running to clean it? Philips lists a quick-clean method for models including HR2004/70: use up to 500ml of water, a little dishwashing liquid and several pulses, then rinse. Keep jar cleaning separate from cleaning the motor base.

Storage baskets on a wooden shelf; reference photograph

Based on the sources linked below. The photograph is for illustration.

Before you start

STEP BY STEP

Here’s how

01

1. Check the model and jar

Philips lists HR2010/70, HR2004/70 and HR2006/70 on the jar-cleaning page. This guide follows that advice and the instructions linked from the HR2004/70 support page. For another model, check its own cleaning instructions first. Switch off and unplug the appliance before preparing or handling its components. Confirm that power is disconnected before reaching near the blades. Do not run a cleaning cycle with a damaged jar or component.

02

2. Add no more than 500ml of water

Put measured water and a little dishwashing liquid in the empty jar. The quick-clean instructions specify a maximum of 500ml of water. The jar's normal processing capacity is not the amount to use for this procedure. For example, after measuring 500ml, do not top it up to fill the jar. Philips does not specify an exact milliliter dose of detergent here, so do not invent one or mix stronger chemicals. This is not a boiling-water sterilization procedure.

03

3. Check the lid, then pulse several times

Make sure the jar, lid and lid's measuring cup are correctly fitted according to the instructions before preparing to run it. The quick-clean method uses several pulses, rather than a long continuous run. Do not open the lid or put hands or utensils inside while it is running. If water leaks or the assembly seems wrong, switch off and unplug before inspecting. Never hold down or bypass a safety interlock.

04

4. Stop, unplug and rinse

Finish pulsing, switch off and wait for the blades to stop. Unplug, remove the jar, discard the wash water and rinse with clean water. Running the detergent mixture is not the final step. Check for food still clinging to the jar. If residue remains, follow the model's instructions for cleaning removable parts instead of wiping between blades with your fingers. Do not assume the quick cycle removed every deposit.

05

5. Wipe the motor base separately

Do not immerse the motor base or rinse it under a tap while washing the jar. Philips specifies a damp cloth for the base. Distinguishing the washable jar from the electrical base is essential. Keep the appliance unplugged while reassembling components as instructed. If leaking continues or parts do not fit correctly, stop using it and contact the manufacturer with the model number and details of the problem.

Sources & further reading

Philips — How to clean the blender jar ↗Philips HR2004/70 — Official support and manuals ↗Philips Daily Collection — Important safety information ↗

Some sources are in Korean. Check the original guidance for current product, store or software conditions.

Read this article in Korean →