← Living
Living

Dyson Supersonic filter cleaning: keep the HD08 cover and mesh dry

For Dyson Supersonic HD08 filter cleaning, first check whether water is permitted. This guide follows the official manual: unplug and cool the dryer, remove dust from the cover and inner mesh with a dry cloth or soft brush, then align and lock the cover again.

Storage baskets on a wooden shelf; reference photograph

Based on the sources linked below. The photograph is for illustration.

Before you start

STEP BY STEP

Here’s how

01

1. Match the HD08 instructions to your dryer

Dyson's Supersonic support page recommends monthly removal of dust and lint, and its linked HD08 manual explains regular filter cleaning. Compare your dryer with the diagram to identify the filter cover near the bottom of the handle. This article follows the HD08 dry-cleaning procedure. Do not combine removal or washing methods from different Supersonic models simply because they share the name. If the model is unknown or its construction differs from the illustration, check its identification and obtain the matching manual first.

02

2. Unplug, let it cool, then release the cover

Switch off, unplug from the socket and let the dryer cool before cleaning. Do not start immediately after drying your hair. Prepare a dry work area, cloth and brush so you do not need to move around looking for tools with the cover open. Hold the handle securely, turn the filter cover counterclockwise and lower it to expose the mesh. This opens the cover; it is not an instruction to dismantle the handle or motor. If the cover does not move as illustrated, stop and recheck direction and model rather than forcing it.

03

3. Inspect and clean both the cover and inner mesh

Remove dust and lint from both parts with a dry, lint-free cloth or soft brush. Cleaning only the outer cover can leave debris on the mesh. The official manual says not to use water or apply excessive pressure to the mesh. For example, a clean-looking cover does not establish that the mesh beneath is clean. Do not poke its openings with a pointed tool or scrub hard to shift stubborn residue. If gentle dry cleaning is insufficient, stop and ask Dyson about an appropriate method.

04

4. Align and lock the cover, then record the date

Check for remaining debris, raise and align the cover in its original position, then turn it clockwise to lock. If it sits at an angle, correct its alignment rather than pushing harder. Do not resume use unless it is secured properly. Record the cleaning date and inspect both parts at the next monthly check. If weak airflow or unusual behavior continues, note the model and symptoms and request support rather than assuming dust is the only cause. Whentip has not measured airflow before and after this procedure.

Sources & further reading

Dyson official support — Supersonic filter cleaning ↗Dyson official HD08 manual — Regular filter cleaning ↗

Some sources are in Korean. Check the original guidance for current product, store or software conditions.

Read this article in Korean →