← Living
Living

How to wash a Dyson Digital Slim filter: cold water and at least 24 hours to dry

If your Dyson Digital Slim shows a filter reminder, or a month has passed since its last wash, plan time to wash the detached filter and let it dry completely. This guide follows page 7 of the Korean Digital Slim manual, from removing loose dust to rinsing, drying and refitting.

Storage baskets on a wooden shelf; reference photograph

Based on the sources linked below. The photograph is for illustration.

Before you start

STEP BY STEP

Here’s how

01

1. Check the model and plan the wash

Check that your vacuum and manual are for the Dyson Digital Slim. These instructions follow the filter-cleaning section in the linked Korean PDF; do not automatically apply them to another Dyson model. The manual calls for washing at least monthly or when the filter icon appears. Frequent fine-dust cleaning or Boost-mode use may require more frequent washing. Choose a day when the filter can stay out of use for at least a full day, rather than washing just before you need the vacuum again.

02

2. Remove the filter and loosen dry dust first

Stop the vacuum, then carefully twist the rear filter anticlockwise to remove it. Take only the detached filter to the washing area so that you do not confuse it with parts that should remain dry. Tap the filter gently over a bin to release loose dust and debris. This prepares it for rinsing; the disappearance of loose dust does not mean the washing process is complete.

03

3. Rinse the outside and inside with cold water

Wash the outside with cold water, gently rubbing it with your fingers to remove debris. Cover one end, fill the filter with water, cover the other opening and shake it to wash the inside. Empty it and repeat until the water runs clear. This model's PDF specifies cold water and prohibits detergent, polish and air freshener. Do not add a soapy or scented treatment. It also says that no part of the machine should go in a dishwasher.

04

4. Stand it open-end up and dry for at least 24 hours

Shake out the remaining water, then stand the filter with its open end facing upwards, as shown in this PDF. Choose a stable spot where it will not fall back onto a wet surface. Allow at least 24 hours, and refit it only when completely dry. For example, a wash finished at 8 p.m. reaches the minimum interval at 8 p.m. the next day, but any remaining moisture means it needs longer. This is a scheduling example, not a guarantee that the filter will be dry by that time.

05

5. Refit the dry filter and check that it locks

Push the completely dry filter against the main body and twist clockwise until it clicks into place. Do not fit it damp and expect running the vacuum to dry it. If it will not fit correctly or a filter message remains, compare the installation diagram with your machine before forcing it or washing it again. If the problem is unclear, identify the model and contact Dyson support.

Sources & further reading

Dyson — Digital Slim Korean user guide, page 7: cleaning the filter ↗

Some sources are in Korean. Check the original guidance for current product, store or software conditions.

Read this article in Korean →