← Living
Living

Clean a Duplex DP-D50CF fan: dry the blade's center hole before storing it

Before storing a Duplex DP-D50CF fan for winter, check the disassembly directions and the areas that must dry. This guide follows the official manual from disconnecting power through removing the guard and blade, wiping, reassembling and storing.

A workspace with a laptop and monitor

Based on the sources linked below. The photograph is for illustration.

Before you start

STEP BY STEP

Here’s how

01

1. Check the model and disconnect the adapter

Confirm DP-D50CF on the product label. This guide covers that Duplex Nano BLDC circulator-style fan; other models may have different nut directions and rear-guard designs. Switch off, wait for the blade to stop, and disconnect the adapter from the power supply and fan. Use dry hands and do not pull the cable to unplug it. Prepare a place for the screw and nut so they are not lost before reassembly.

02

2. Check the guard and nut directions separately

Undo the front-guard securing screw with a Phillips screwdriver. Turn the front guard slightly counterclockwise and pull it forward. The blade-locking nut, however, turns clockwise to come off before you remove the blade. The manual states that the rear guard is not removable. Do not force it off or open the motor housing. If a part will not move, compare its position with the illustration on manual page 5 before applying more force.

03

3. Wipe while keeping electrical parts dry

The manual calls for a soft cloth moistened with soapy water or detergent solution, followed by a cloth moistened with clean water to remove suds, then a dry cloth. Keep moisture away from electrical areas such as the motor and buttons. Do not immerse the body or spray water inside it. Do not use benzene, thinner or alcohol for stubborn dirt. If water gets inside, keep power disconnected and contact service rather than switching it on as a test.

04

4. Dry the blade's center hole completely

After washing the detached blade, let it dry before assembly. Pay particular attention to the center hole that fits over the shaft and contacts the motor. A dry outer surface does not establish that this hole is dry too. The manual warns that residual water can travel along the shaft into the bearing area and cause noise. It gives no fixed drying time, so do not declare it ready solely because a certain number of hours has passed.

05

5. Secure the guard and store the adapter with the fan

Fit the blade correctly onto its shaft and secure its nut. Align the front guard's catches and screw hole, turn the guard clockwise into position and replace the securing screw. Check that the front logo is upright. Never run the fan without its guard. Once cleaning and drying are complete, cover the fan and box it in a dry, well-ventilated place. Keep its supplied adapter with it, as the manual requires that adapter. A model-name note can help prevent accidental substitution next season.

Sources & further reading

Duplex — official DP-D50CF manual: cleaning, disassembly and storage ↗

Some sources are in Korean. Check the original guidance for current product, store or software conditions.

Read this article in Korean →