How to clean a BRITA Style XL Eco: remove the Smart Light and stay at or below 50°C
Unsure whether the indicator on your BRITA Style XL Eco can go in the dishwasher? Clean the jug and Smart Light separately. This guide covers BRITA's advice to wash the jug two or three times a week, the dishwasher temperature limit, drying and reassembly.

Based on the sources linked below. The photograph is for illustration.
Before you start
STEP BY STEP
Here’s how
1. Check the model and separate the indicator and cartridge
Confirm that your jug is a Style XL Eco. Do not assume that every BRITA lid has the same cleaning requirements. The official instructions for this model say to remove the Smart Light from the lid before using a dishwasher. Empty the jug and separate the lid, funnel and cartridge. Keep the electronic indicator and cartridge apart from the pieces being washed so they do not accidentally go through the jug's cleaning process. This also makes it easier to check that every part is present when reassembling.
2. Wash the jug with warm water and a soft sponge
BRITA's Korean FAQ recommends cleaning the water filter jug two or three times a week with warm water and a soft sponge. Check the surfaces that contact water, including the jug and funnel. Remove ketchup or mustard promptly if it gets on the plastic, as BRITA warns that it can cause staining. Cleaning the jug is different from cleaning the inside of a cartridge. The FAQ says the cartridge does not need separate internal cleaning or disinfection. For its exterior, BRITA recommends a light rinse under running water two or three times a week.
3. Check that the dishwasher's water temperature will not exceed 50°C
The Style XL Eco product instructions allow dishwasher cleaning at a maximum water temperature of 50°C. First confirm that the Smart Light has been removed, then check your dishwasher's instructions to see whether the chosen programme meets that limit. Do not estimate the temperature from a programme name. If you cannot verify it, hand washing makes it easier to follow the stated conditions. BRITA also advises against washing the jug alongside dishes carrying staining foods such as ketchup or mustard.
4. Rinse the Smart Light lightly and dry it with a soft towel
The FAQ describes the Memo and Smart Light as having only basic water resistance. Clean the Smart Light with a light rinse under running water, then dry it with a soft towel. Do not replace this method with prolonged soaking or a dishwasher cycle. Let the washed jug air-dry, or dry it with a soft towel, before using it again. While the jug dries, check the separate indicator too, so you are not rushing to refit it while wet.
5. Align the lid and funnel before closing
Put the parts back in place, align the notch at the rear of the lid with the funnel's notch, and press the lid firmly closed. If it does not fit, check the orientation of the funnel and lid before applying more force. Distinguish routine jug washing from installing a new cartridge. Discarding the first two filtered fills belongs to the separate new-cartridge preparation instructions. Washing the jug does not make an existing cartridge new or extend its replacement interval.
Sources & further reading
BRITA Korea — Style XL Eco use and cleaning instructions ↗BRITA Korea FAQ — jug and cartridge cleaning, and water storage ↗Some sources are in Korean. Check the original guidance for current product, store or software conditions.
Read this article in Korean →
